Maintenance and operation of hydraulic non firing brick making machine

The maintenance operation of the hydraulic non fired brick making machine can only be used by the maintenance personnel of the hydraulic non fired brick making machine. At this time, the rising and falling of the punch can only be carried out at a low speed (less than 16mm / s), which is convenient for replacing the mold. In addition, the powder pushing frame at the back or the billet conveying equipment at the front can be moved away to access the hydraulic brick making machine. Note that do not operate when the equipment is running. The hydraulic no burning brick making machine is also equipped with two emergency stop buttons. One is on the control box and the other is behind the device. In case of emergency, if one of these two buttons is pressed, the equipment will stop immediately and the oil pump will be depressurized.

How to install the equipment, the equipment layout in the manufacturer’s intention is given below. The normal operation of the equipment can only be ensured by the layout according to the drawing. Although the equipment for taking out and transporting bricks is not an integral part of the hydraulic no firing brick making machine, it is essential for reliable safety. There is an electronic instrument sensor on it to monitor the position of the brick conveying belt. The sensor should be connected in series with other safety devices on the hydraulic no firing brick making machine. Stop the equipment for cleaning. Press the buttons 25 and 3 on the control box to raise the punch completely. Raise the side of the safety bar to use. Note: when cleaning the mold, the staff must wear protective clothing to prevent scalding. For more thorough cleaning, follow the operation rules of maintenance of hydraulic brick making machine.