Composite sand permeable brick born out of the world

As the core product on top of the pyramid of permeable brick system, after years of development, there are still many defects: low productivity, artificial intervention links, low rate of finished products, surface layer color mixing, products alkali white.

Through unremitting efforts, Honcha has finally successfully launched the sand based permeable brick of secondary composite molding. Customers only make the bottom layer permeable big board on the original equipment, and then Honcha helps its composite sand based surface layer to cut, pack and sell according to the specifications required by customers. Before that, almost all brick factories would have some obsolete products, and all orders and production capacity could not match completely, resulting in a certain amount of inventory in each order. If the inventory is kept for a long time, surface pollution and color change will occur, and its gorgeous degree will decline. Several years down, sell, do not sell; save, occupy the site; throw, reluctant! With Honcha new technology, we will only make the most economical and cost-effective inventory, just stock the general board. However, before that, they were generally afraid to do inventory work, which led to the fact that they could only work overtime continuously after receiving an order. They often did not dare to accept large orders, unable to deliver on time, and the user had no choice but to change the design. The new process will achieve the state of zero obsolete products.

Previously, only 60 to 80 molding cycles could be completed per hour, and perforated slabs could be made from 180 to 240 plates per hour, which greatly released the production capacity. A variety of colored fabrics are laminated and laminated before leaving the factory. The materials are independently stirred and formed, and they will never mix with the finished product. The surface is beautiful and flawless. The new process produces a new industrial revolution of sand-based bricks, which has the following characteristics: 1. Separate molding and no color mixing; 2. The production capacity is 2 to 3 times larger than the traditional process, which is particularly suitable for short-term high-density supply; The thickness of the layer is consistent and controllable; 4. There is no waste of defective products, repair can be repaired, can not be reworked immediately; 5, the appearance dimensions are absolutely accurate and error-free; 6, the lower surface of each partition block less than 10 cm blind bars It has the effect of saving the amount of fabric and increasing the adhesion of the surface layer; 7. Reduce the mold investment and inventory pressure, and compound and cut any specifications before leaving the factory; 8. The oversized products have the exclusivity in the market; 9. The cutting surface and the corners are neat, there are no moulded lines, and the imitation stone surface is more like real stone. 10. It can effectively avoid the alkali return of products and the factory products have bright colors and no color difference. The new industrial revolution will bring good returns to users and quickly promote the construction and development of sponge cities!

Honcha is proudly launched!